Specifications
| Product type | Elastic shaft coupling |
| Reference brand | KTR |
| Size designation | 14 inch |
| Mating style | Flanged, bolt-on |
| Mounting | Evenly spaced bolt circle on the flange |
| Fitted position | Crane driveline |
| Finish | Matte grey machined steel with a polished centre |
| Spare category | Coupling / driveline component |
| Flange form | Flat circular flange with a central toothed bore |
| Centre detail | Recessed machined centre inside the flange face |
Part Numbers & Identification
The number on the part
Two reference numbers identify this coupling: 393749 and D-48407, and either may be the marking on your old unit. Read the number stamped or cast on the flange first, then check the bolt-hole count and spacing on your mounting face, the pilot diameter and the 14 inch size against the coupling you are removing. A photo of the old part with a rule laid across the flange is usually enough for us to confirm the match.
Checking it with us
Cross-checking a number is part of the process rather than an extra step, and we do it daily as a crane parts supplier to workshops and fleet operators. If the marking on your unit has been superseded, send it over and we will check what it corresponds to.
Where it sits in our range
This coupling is one of the construction machinery spare parts we keep for crawler cranes, drilling rigs and other heavy plant, so it travels well with the seals, bearings and fasteners that usually go into the same driveline job.
Applications & Fitment
- Driveline repair on a crawler crane – When a machine comes in with a knock or a fresh vibration through the driveline, this coupling is the part that goes back on, and renewing it removes the guesswork about an interchangeable number.
- Workshop overhauls – On a gearbox or driveline rebuild the coupling is normally renewed rather than re-used, because a ribbed ring that has already taken years of shock loading will not seat the way a fresh one does.
- Scheduled fleet inspection – Fleets that pull and inspect driveline couplings at set service intervals keep one on the shelf so the machine goes back to work the same day.
- Parts counter and importer stock – Distributors stocking crane parts for Chinese-built crawler cranes carry this reference beside the seals, bearings and fasteners that move with it.
- Breakdown response – On a site stop, the fastest route back to work is a confirmed reference, so send the marking from the old coupling with photos of the flange before you commit.
Fitting & Alignment
- Lock out the machine and make sure the driveline cannot turn before you start, and support anything that will move once the coupling is released.
- Photograph the coupling in place and mark the flange position on both halves so the replacement goes back in the same orientation.
- Clean the shaft and the mounting face, and dress off any burrs or raised metal on the flange before the new coupling goes on.
- Slide the coupling onto the shaft until it seats fully against the face. Do not draw it up with the bolts, because that loads the hub before the driveline is even running.
- Tighten the flange bolts in a cross pattern in two or three passes, working to the torque figure from your machine manual rather than a general table.
- Turn the driveline by hand and listen. If you can feel binding or hear a knock, check alignment and seating again before the machine goes back to work.
Technical Support & Model Matching
Not sure which part fits your machine? Send us the OEM part number, the machine model, and a photo or drawing, and we will help you match the correct item. We supply crane and construction machinery spares across Cummins, SANY, Caterpillar and FUWA applications, covering solenoid valves and coils, angle sensors, wiring harnesses, couplings and load moment indicators. We also assist with fitting questions, wiring checks and fault tracing, and can produce custom parts to your drawings when a standard item is not the right answer.